Table of Contents
t1unmac - translate a Mac PostScript font into PFA or PFB format
t1unmac [-a |-b ] [-r ] [input [output ]]
t1unmac
extracts POST resources from a Macintosh PostScript font file and creates
a PFA (hexadecimal) or PFB (binary) font file. The file input should be
in MacBinary I or II, AppleSingle, AppleDouble, or BinHex format, or it
can be a raw resource fork. If the file is a raw resource fork, you need
to give the `--raw' option; otherwise t1unmac should automatically figure
out what kind of file you have. If the file output is not specified output
goes to the standard output.
- --pfa, -a
- Output in PFA (ASCII) format.
- --pfb, -b
- Output in PFB (binary) format. This is the default.
- --raw, -r
- Indicates
that the input is a raw resource fork.
- --macbinary
- Indicates that the input
is in MacBinary I or II format.
- --applesingle
- Indicates that the input is
in AppleSingle format.
- --appledouble
- Indicates that the input is in AppleDouble
format.
- --binhex
- Indicates that the input is in BinHex 4.0 format.
- --block-length=num
, -l num
- PFB only: Set the maximum output block length to num. The default
length is as large as memory allows.
- --line-length=num , -l num
- PFA only:
Set the maximum length of encrypted lines in the output to num. (These
are the lines consisting wholly of hexadecimal digits.) The default is
64.
t1mac(1)
, t1ascii(1)
, t1binary(1)
, t1asm(1)
, t1disasm(1)
Lee Hetherington (ilh@lcs.mit.edu)
Eddie Kohler (eddietwo@lcs.mit.edu)
Ported to Microsoft C/C++ Compiler and
MS-DOS operating system by Kai-Uwe Herbing (herbing@netmbx.netmbx.de).
Table of Contents